I always compare this to a typical motor or compressor circuit where the short circuit protection is at the supply end, often much higher than the conductor ampacity, and the overload protection is provided at the load end.
Mike: I would think the NEC Tap rule could apply here (240.21) especially if the cord is 25'. Probably not exactly where the code writers expected it to be applied but practically speaking it is a safe practice as you described.
People get freaked out by this but are perfectly happy plugging an 18 gauge power cord into a 20 amp outlet.
People get freaked out by this but are perfectly happy plugging an 18 gauge power cord into a 20 amp outlet.
Deoxit D5 spray sounds reasonable to use each hookup!
I always compare this to a typical motor or compressor circuit where the short circuit protection is at the supply end, often much higher than the conductor ampacity, and the overload protection is provided at the load end.
Mike: I would think the NEC Tap rule could apply here (240.21) especially if the cord is 25'. Probably not exactly where the code writers expected it to be applied but practically speaking it is a safe practice as you described.